REVISTA MINERÍA 540 | EDICIÓN SEPTIEMBRE 2022

MINERÍA la mejor puerta de acceso al sector minero MINERÍA / SEPTIEMBRE 2022 / EDICIÓN 540 32 Recuperaciones en la lixiviación en pilas Las recuperaciones de cobre en el pad 4B, en el nivel 15, promedian 1.7% menos que el modelo metalúrgico. A partir del nivel (capa) 11, el tamaño de partícula del mineral se incrementó de 35 a 45% +3/8". Es importante considerar que el inventario de Cu se puede perder debido a este incremento de tamaño. Como se mostró en la sección anterior, la recuperación puede verse afectada en un 8 a 9% cuando el tamaño de partícula se incrementa en un 10%, por lo que el trabajo futuro es revisar cuidadosamente el mejor escenario económico para el parámetro del P80 en las operaciones de lixiviación. Ratio gruesos/finos control del contenido de finos y arcillas El ratio gruesos/finos, relación del contenido de toneladas de finos referido a mallas –M 200 y –M 100 respecto a las toneladas de gruesos representados en la fracción +3/8”, es el índice de seguimiento de la permeabilidad que se tiene en el mineral apilado en el pad. En base a las diferentes pruebas descritas anteriormente se estableció los siguientes KPI: Figura 21. Fracción -200 M al inicio y después del primer ciclo de lixiviación. Figura 22. Decrepitación a través del ciclo de lixiviación. Figura 23. Decrepitación a través del ciclo de lixiviación (2/2). samples obtained at higher leaching cycles are not significantly affected. Heap Leach Recoveries Copper recoveries in pad 4B, at lift 15, average 1.7% less than the metallurgical model. Starting at lift 11, the particle size of the ore increased from 35 to 45 %+3/8". It is important to consider that Cu inventory may be lost due to this increase in size. As shown in the previous section, recovery can be affected by 8 to 9 % when the particle size is increased by 10 %, so future work would involve carefully reviewing the best economic scenario for the P80 parameter in Leaching Operations. Coarse/Fine Ratio - Control of Fines and Clays Content The coarse/fine ratio, which is the ratio of tons of fines content referred to -M200 and -M100 mesh to tons of coarse represented in the +3/8" fraction, is the ore stacked permeability monitoring index in the pad. Based on the different tests described above, the following KPIs were established: Conclusions 1.It is possible to achieve a good quality of agglomeration at 8% +3/4". 2.Permeability increases significantly when the +3/8" fractions go from 30 to 40-45%. 3.With an ore content of up to 5% swelling clay (SC) the permeability remains the same when the coarse fraction (3/4" and 3/8") is increased. 4.At 30 % +3/8" decrepitation almost doubles the fine fraction after the first leaching cycle.

RkJQdWJsaXNoZXIy MTM0Mzk2